L_G_K
November 15th, 2007, 11:28 AM
I have assembled my new Powertec WB-LS and can't wait to use it. I have set the system through its paces to see how everything worked and how to incorporate it into a workout.
My only issue - squats. I watched the video and the guy doing the squats was standing on the middle of the floor plats and squatted without trouble. When I stand the same way with the bench out of the way and in full decline my butt hits the pad. My specs 5'10" 162 lbs without and junk in my trunk so a rear bumper is not the problem.
I note that the system in the video was different than the one on the exercise poster which differed from the one in the assembly booklet which differed from the one I actually assembled. Differences were slight, but there.
Any suggestions would be appreciated.
-L_G_K
My only issue - squats. I watched the video and the guy doing the squats was standing on the middle of the floor plats and squatted without trouble. When I stand the same way with the bench out of the way and in full decline my butt hits the pad. My specs 5'10" 162 lbs without and junk in my trunk so a rear bumper is not the problem.
I note that the system in the video was different than the one on the exercise poster which differed from the one in the assembly booklet which differed from the one I actually assembled. Differences were slight, but there.
Any suggestions would be appreciated.
-L_G_K